Lull 644B Operation Manual - Manual (Page 30)

26
FLUID & LUBRICANT SPECIFICATIONS
GENERAL FLUID AND LUBRICANT
SPECIFICATIONS
1. Consult engine manufacturer’s Operator’s
Manual for additional information.
ENGINE OIL SPECIFICATIONS
John Deere Engines
Use the table below to select the oil viscosity based on
expected air temperature range during the period
between oil changes. Consult the John Deere
Operator’s Manual for additional information.
Note: New John Deere engines use special break-in oil
for the initial period of operation. Consult engine
Operator’s Manual for additional information.
General Fluid & Lubricant Specifications
System or
Component
Fluid or
Lubricant
Specification
Fuel System
1
See “Fuel Requirements”
Hydraulic
System Heavy Duty
Hydraulic Fluid Amoco Rykon
MV or equiv.
Engine Cooling
System
1
Ethylene Glycol/
Pure Water Mix
with additives. Low silicate
Ethylene Glycol
ASTM D5345
ASTM D4985
Engine Oil
1
See “Engine Oil Specifications”
Transmission See “Transmission Oil
Specifications”
Differential
(Front & Rear) Gear Lubricant SAE 90 API GL-5
Planetary Hub Use 58 oz. SAE 90 API GL-5 and 4
oz. Friction Modifier, LULL
® P26720
Grease Points Grease Lithium-based
Engine Oil Selection Chart, John Deere
Engine Oil, John Deere
Oil Grade
Temperature
Range ° F
Temperature
Range ° C
SAE 5W-30 -22 to +86 °F -30 to + 30 °C
SAE 10W-30 -4 to +86 °F -20 to +30 °C
SAE 15W-40 +5 to 122 °F -15 to 50 °C
SAE 30W +32 to +86 °F 0 to +30 °C
SAE 40W +50 to +104 °F +10 to +40 °C
Arctic Oil (e.g.
MIL-L-46167B)
Below -22 °F Below -30 °C
Approved Engine Oil Specifications
API CD/ CE
CCMC Specification D4, D5
SAE 5W-30
SAE 10W-30
SAE 15W-40
SAE 30W
SAE 40W
MIL-L-46167B