Lull 644E-42 Operation Manual - Manual (Page 90)

88 Model 644E Origin 3/04
Operation
To pick a load, move the forks inward or outward on the fork shaft so that they are
aligned with the openings in the pallet. Extend the boom slowly so the forks slide into
the openings in the pallet. Raise the boom so that the load is lifted.
To carry a load, position the boom so that the load is as low as possible and the
travel area is visible to the operator.
Before placing the load, use the capacity chart to determine safe boom extension
range for the applicable load. To place a load, align the forks at the level the load is
to be placed and then extend the boom slowly until the load is just above the area
where it is to be placed. Lower the boom until the pallet rests in position and the
forks are free to retract.
The transfer carriage extension can be used to place the load onto the landing point,
being certain that the load on the forks is within the transfer limits shown on the
individual capacity charts.
How To Pick, Carry & Place A Load