Using the coupling extractor, Maintenance and cleaning, Accessories – IKA Tube Mill control User Manual
Page 21
21
Using the coupling extractor
Milling tube coupling broken:
The milling tube coupling may be broken when the
grinding material is too much or too hard.
Pull the broken coupling out from the drive unit:
Fit the coupling extractor in clockwise direction. The
coupling puller is properly attached to the coupling af-
ter a “click“.
Turn the coupling extractor in counterclockwise direc-
tion. The broken coupling will be extracted out after
a “click“.
CLICK
I
II
CLICK
III
Maintenance and cleaning
The instrument is maintenance-free. It is only subject to
the natural wear and tear of components and their statisti-
cal failure rate.
Cleaning
Disconnect mains plug prior to
cleaning!
- Wear protective gloves when cleaning the devices.
- Do not place electrical appliances into the cleaning
agents for cleaning purposes.
- Do not allow moisture to get into the appliance when
cleaning.
- Please consult IKA
®
before using any cleaning or decon-
tamination methods, other than those recommended
here.
- The device must not be washed in a dishwasher.
- The protective hood is of polycarbonate and can be treat-
ed using commercially-available disinfectants. Avoid prod-
ucts that contain aldehydes, phenols, acetone or alcohol.
- It should be cleaned only by hand using a liquid disin-
fectant.
- The only cleaners or disinfectants that may be used are
those that:
- lie in the pH range 5 - 8,
- contain no corrosive alkalis, peroxides, chlorine
compounds, acids or brine.
- If rotator becomes contaminated with milled material,
clean it thoroughly with vacuum cleaner.
Only clean IKA
®
appliances using these IKA
®
approved
cleaning agents. To remove use:
Dirt
Cleaning agent
Dyes
isopropyl alcohol
(do not use for the protective hood)
Building materials water containing detergent, Isopropanol
(do not use for the protective hood)
Cosmetics
Water containing detergent, Isopropanol
(do not use for the protective hood)
Food
Water containing detergent
Fuels
Water containing detergent
Other materials
Please consult IKA
®
Spare parts order
When ordering spare parts, please give:
- Machine type
- Serial number, see type plate
- Item and designation of the spare part,
see www.ika.com, spare parts diagram and spare
parts list
- software version.
Repair
Please send instrument for repair only after it has
been cleaned and is free from any materials which
may constitute a health hazard.
For this you should request the “Decontamination
Clearance Certificate” from IKA
®
, or use the download
printout of it from the IKA
®
website www.ika.com.
Return the instrument in its original packaging. Storage
packaging is not sufficient. Also, please use suitable ship-
ping package material.
Accessories
•
MT 40 milling tube
• Labworldsoft
®