JLG 40RTS Service Manual - Manual (Page 45)

SECTION 2 - PROCEDURES
3120826 – JLG Sizzor – 2-29
3. Apply a light coat of “Never-Seize” to two pipe plugs
and tighten them into two pipe plug holes in side of
hub.
NOTE: Make sure cup sits square with counter bore before
pressing.
4. Turn hub over onto its small end. Press bearing cup
down into counter bore in deep end of hub.
5. Set hub onto its large end. Place bearing cone into
bearing cup.
6. Press seal into small end of hub.
7. Oil spindle, then lower hub, small end down, onto
spindle.
8. Press bearing cone onto spindle in hub.
9. Place spacer onto spindle in hub.