JLG 450A_AJ Series II Service Manual - Manual (Page 424)

SECTION 7 - BASIC ELECTRICAL INFORMATION & SCHEMATICS
7-8 – JLG Lift – 3121180
7.4 DEUTSCH CONNECTORS
DT/DTP Series Assembly
1. Grasp crimped contact about 25mm behind contact
barrel.
2. Hold connector with rear grommet facing you.
3. Push contact straight into connector grommet until a
click is felt. A slight tug will confirm that it is properly
locked in place.
4. Once all contacts are in place, insert wedgelock with
arrow pointing toward exterior locking mechanism.
The wedgelock will snap into place. Rectangular
wedges are not oriented. They may go in either way.
NOTE: Receptacle shown - use same procedure for plug.
DT/DTP Series Disassembly
1. Remove wedgelock (A) using needlenose pliers or a
hook shaped wire to pull wedge straight out.
NOTE: Hold rear seal in place. Removing contact may dis-
place seal.
2. Gently pull wire and contact out of connector (C),
while at the same time releasing locking finger by
moving it away from contact with a screwdriver (B).
Figure 7-12. DT/DTP Contact Installation
A B
C D
Figure 7-13. DT/DTP Contact Removal
A B
C