IOGear GHSW8242 Manual - Manual (Page 16)

16
The following table shows the available command list:
Command Control Enter Description
pod on [Enter] POD enabled (default)
pod off [Enter] POD disable
Verification
After entering a command, a verification message appears at the end of the command line as
follows:
• Command OK - indicates that the command is correct and successfully performed by the
switch
• Command incorrect - indicates that the command has the wrong format and/or values.
Powering Off and Restarting
If you power off the GHSW8242, follows these steps before powering it on again:
1. Power off the attached devices.
2. Unplug the power adapter cable from the GHSW8242.
3. Wait 10 seconds, and then plug the power adapter cable back in.
4. After the GHSW8242 is powered on, power on the attached devices.