Echo CH8993H Owners Manual v.6 - Manual (Page 10)

6 8 INCH TURNTABLE CHIPPER
Section
assemBlY
1. Mount tires and rims to the axle using the lug nuts.
2. Attach the fender supports to the trailer using three 1/2
x 3-1/2" hex bolts, washers & nuts.
3. Attach the fenders to the fender supports using four 3/8
x 1" carriage bolts, washers and nuts.
2
warninG
If any bolts or nuts are dropped in the machine, be
sure to remove them before starting the machine.
2.1 Tires & rims
2.2 Trailer hiTch
1
2
3
4
5
6
6
7
7
8
9
10
11
12
13
14
15
16
17
Figure 2.3, CE Compliant Hitch Assembly
non ce comPlianT (FiGure 2.1)
1. Place hitch pole assembly (8) into the frame, align
mounting holes to desired length and secure using
two 1/2” x 4-1/2” bolts, washers and nuts (hardware
not shown in Figure 2.1). Torque to 75 ft-lbs.
2. Attach coupler mount (7) to hitch pole using two 5/8”
x 4 1/2” bolts (1), washers (2) and centerlock nuts(5).
Torque to 150 ft-lbs.
3. Attach 2" coupler (6) to coupler mount using two 1/2
x 4" bolts (3) and centerlock nuts (4). Torque to 75
ft-lbs.
Figure 2.2, Remove this clevis on 50mm coupler
Figure 2.1, Non-CE Compliant Hitch Assembly
1
2
3
4
5
6
7
8
ce comPlianT (FiGure 2.3)
1. Place hitch pole (13) into machine frame. Place one
1/2” x 4 1/2” bolt, washer and centerlock nut through
frame and end hole of hitch pole. Next, align the brake
rod hanger bracket (11) (as shown in figure 2.3) to the
other mouting hole and secure by placing the second
1/2” x 4 1/2” bolt (5) through the frame and hanger
bracket, add washer (6) and centerlock nut (7). Torque
both to 75 ft-lbs.
2. Attach 50mm coupler (4) to hitch pole (13) using two
1/2 x 4" bolts (8), washers (6) and nuts (7). Torque to
75 ft-lbs.
3. Attaching the brake rod (14) to the coupler will require
the removal of the clevis shown in Figure 2.2. Figure
2.2 is an underneath view of the coupler.
4. Route the brake rod (14) through the brake rod hanger
bracket (11). Once routed, thread 3/8 jam nut (17) and
3/8" bearing rod end (9) on to the brake rod. Connect
rod end to the coupler, at the location where the clevis
was removed in step 3. secure to coupler with 3/8 x 1
1/2" bolt (15) and nylock nut (16).
5. Attach 3/8" adjustable clevis (2) to other end of break
rod. Connect clevis to brake bar plate (12) with 3/8 pin
(1) and cotter pin (10).
6. Attach brake bar plate to the brake cables of the
machine with 5/16 pins (3) and cotter pins (10)