Isdn parameters – general – 2N StarGate/BlueTower v5.5 User Manual
Page 74
74
Tones Generated to VoIP
– generate a ringing tone of your own, or transmit a real
Ring tone to VoIP
ringing tone from the GSM/UMTS networks.
ISDN Parameters – General
Use this window to set the PRI ISDN port parameters.
PRI Mode Selection
Here define the PRI 1 (2) ISDN port type.
Synchronisation – define if the gateway will send the synchronisation clock
(MASTER) or receive the synchronisation clock from the connected line (SLAVE).
PRI1 / PRI2
Channel number select – define the way of occupation of B-channels on a
selected ISDN PRI interface. With the UPWARDS selection, the gateway will
occupy the B-channels upwardly (from the selected B-channel number to the
B-channel 32). With the DOWNWARD selection, the gateway will occupy the
B-channels in the descending order (from the selected B-channel number to
B-channel 1).
Preferred channel – select a B-channel.
Note
In case the GSM gateway is installed behind the NAT, make proper routing
settings in the NAT router for the relevant ports (SIP, RTP, STUN).
Integrated firewalls can also affect VoIP calls!
Tip
Should you have call troubles (such as unilateral audibility, connection
errors), make sure that all the active elements on the VoIP call route have
been set properly. For easy troubleshooting, try the point-to-point
connection with the software IP phone (SJ phone, e.g.) in your PC and, at
the same time, apply network analyser tracing (WireShark –
Refer to the
subsection for easy tracing by
2N StarGate
®
.
/ BlueTower
Note
The PRI 1 port is always set as internal – the LCR function is activated.
The PRI 2 port is always set as external – all calls from PRI 2 are rerouted
to PRI 1. The PRI 2 port has a mode opposite to that of the PRI 1 port.
In the case of ISDN port mode change, change the selection of the ISDN
PRI card jumpers, see the PRI Board subsection.