Anchor NAVI-TRAC FRAME LIFT - Manual

NAVI-TRAC FRAME LIFT
ASSEMBLY INSTRUCTIONS
See Image “A”
1. Attach the lower end (2-hole pattern) of the Bottom
Post (#5) to the rear most splice stub of the Base
Weldment (#1) (use Hdw #9 & 10). The single,
centered channel of the post should face forward.
2. Insert the Leg Inserts (#2) and pin with (#14).
3. The Turf Wheels (#21) have been pre-installed.
4. One at a time, remove the bolts (#9 & 10) holding the
splice at the top of the Bottom Post (#5) to install the
Hinges for Brace (#8) on each side of the bottom post.
Secure the hinges by replacing the same hardware
(9 & 10).
See Image “B”
5. Install the Brace Weldments (#4) to the Brace Hinges (#8) on both sides of the bottom post (use hdw #16 & 17) at the brace
hinge (#8)
6. Lean the Frame Lift over, as needed, to slide the Top Post (#7) onto the Splice of the bottom post and secure (use hdw #15).
7. To limit the spread of the Brace Weldments, install Eyes (#12 & 13) into the bottom post and attach the 36” web (#11) between the
brace (use hdw #20 & 21) and the bottom post (use snap #18).
See Images “C, D, & E”
8. While the Frame Lift is leaned over, attach the pre-assembled lifting web and winch assembly starting with the Winch Assembly
(#24) to the Bottom Post (use hdw #25 & 26). See images C and D.
5
9,10
1
6 9,10
2
14
A
8
B
7
4
16,17
15
12,13
11
20,21
18
Phone: 812-867-2421
Fax: 812-867-0547
E-mail: www.anchorinc.com 1100 Burch Drive.
Evansville, Indiana 47724
9. Next, feed the web assembly to the top and insert the Web Top Weldment (#3) into the top of the Top Post (#7) and secure with
(hdw #9,10). The Eave Hook (#27) should hang at the front of the Lift with the cup forward and can be secured to the front splice
stub of the base plate when not in use. See Image “F” for storage of the Frame Lift when not in use.
10. Follow the instructions in the Navi-Trac Assembly Manual for proper positioning and use of the Navi-Trac Frame Lift for
assembling and standing the Navi-Trac frame.
C D
Lifting Web
Spring
Shaft Extension
Washer
Bolt
Handle
Winch Assembly
Bottom Post
Winch Assembly
Winch Assembly
properly mounted
For warnings, maintenance and
replacement parts, refer to the
Dutton-Lainson booklet that is
shipped with this winch (the B1500)
Warning:
Always position winch assembly as shown in image “D”. Do not
attach upside down - winch brake system may fail.
EC4418 NTFL 0811