Dascom 7010 Programmers Manual DMX - Manual (Page 51)

1-49
Setting ejection (tear-off)
Code [02] [1B] tn
Setting n 0 , 1
0 : Ejection is turned to OFF
1 : Ejection is turned to ON
Function Switches ejection ON and OFF. The contents with this command are
stored in the backup memory and kept valid even if the power is
turned off.
Caution When the auto-cutter and peeling sensor are turned to ON, any
ejection is not performed even if ejection is turned to ON because the
auto-cutter and peeling sensor have priority. Setting of ejection,
however, is kept valid because it is stored in the backup memory, so
ejection will be performed when both auto-cutter and peeling sensor
are turned to OFF.
Example Examples of input data when Ejection ON and OFF are shown below.
Input data [02][1B] t1 When specifying Ejection ON
[02][1B] t0 When specifying Ejection OFF