Dascom T5040 Quick Start Guide - Manual (Page 11)

Quick start guide Installation
7
EN
GLIS
H
` Checking the printer
voltage Make sure that the device has been set to the correct voltage (e.g. 230 V in Europe,
120 V in the USA). To do this, check the type plate at the back of the printer. Con-
tact your dealer if the setting is incorrect.
Never switch on the printer if the voltage setting is incorrect, since this may result
in severe damage.
` Connecting the printer
Connect the power cable to the power inlet of the printer.
Connect the power cable plug to a mains socket.
Make sure that the printer and the computer are switched off
and connect the data cable between the printer and the com-
puter, in this example a 36-pin centronics parallel cable.
STOP
Quick Start-en.book Seite 7 Dienstag, 5. Dezember 2006 10:48 10