Enerpac SafeLink - Manual

POWERFUL SOLUTIONS. GLOBAL FORCE.
Instruction Sheet
SafeLink Pallet Monitoring System
1.0 IMPORTANT RECEIVING INSTRUCTIONS
Visually inspect all components for shipping damage. Shipping
damage is not covered by warranty. If shipping damage is found,
notify carrier at once. The carrier is responsible for all repair and
replacement costs resulting from damage in shipment.
SAFETY FIRST
2.0 SAFETY ISSUES
Read all instructions, warnings and cautions
carefully. Follow all safety precautions to
avoid personal injury or property damage
during system operation. Enerpac cannot be responsible for
damage or injury resulting from unsafe product use, lack of
maintenance or incorrect product and/or system operation.
Contact Enerpac when in doubt as to the safety precautions and
operations.
A CAUTION is used to indicate correct operating or maintenance
procedures and practices to prevent damage to, or destruction of
equipment or other property.
A WARNING indicates a potential danger that requires correct
procedures or practices to avoid personal injury.
A DANGER is only used when your action or lack of action may
cause serious injury or even death.
Failure to comply with the following hazard alert statements could
cause equipment damage and/or personal injury:
WARNING: Make no modifi cations to any SafeLink
component. Any modifi cations to the product not
expressly approved by Enerpac could void the user’s
authority to operate the product. Contact Enerpac factory for more
information.
WARNING: SafeLink products must only be serviced by a
qualifi ed electronic technician. For factory authorized
repair service, contact the ENERPAC Authorized Service
Center in your area.
WARNING: Never use any component of the SafeLink
system as a sensing device for personal protection. Doing
so could lead to serious injury or death. The SafeLink
system does NOT include the self-checking redundant circuitry
necessary to allow its use in personal safety applications. A sensor
failure or malfunction can cause either an energized or de-
energized sensor output condition.
WARNING: Some SafeLink components are powered by
a 3.6 volt lithium battery. As with all batteries, there is a
fi re, explosion, and severe burn hazard risk. Do not burn
or expose the battery to high temperatures. Do not recharge,
crush, disassemble, or expose the contents to water.
WARNING: All live supply circuits must be disconnected
before wiring the machine control.
WARNING: To avoid personal injury, keep hands and feet
away from fi
xture cylinder(s) and workpiece during
operation.
Note: All specifi cations published in this document are subject to
change. Enerpac reserves the right to modify the specifi cations of
products without notice. Enerpac reserves the right to update or
change documentation at any time.
L3080 Rev. D 06/14
1