ERICO IIP7461 Cable to Lug Horizontal Tap Perpendicular to Flange User Manual
ERICO Accessories for electrical
®
Figure 2
Figure 1
Bottom/Top
Toggle Clamp
ERICO Packing
Material
Vise Grip Clamp
Mold Top
Toggle Clamp
Rope Packing
.25" [6.4 mm]
Lug
Reference Mark
Tap Hole
Disk Seat
Crucible
Prior to making a connection, read and follow the full instruction sheet IPRF, the full instruction
sheet shipped with CADWELD (IPX) and special instructions below.
Clamp bottom of mold to rail using vise grips (Figure 2).
1.
Position lug in mold bottom with .25" [6.4 mm] gap between lug end and rail lip.
2.
Reference mark lug at edge of mold for later use in checking position (Figure. 1).
Place rope packing between mold and rail as shown to help prevent leakage of molten
3.
weld metal (Figure 2).
Lock sections of mold top together using toggle handles. Place on mold bottom and then
4.
lock top and bottom sections together using toggles (Figure 2). Do not over tighten.
Pack all openings between mold and rail (at sides of mold) with ERICO packing material
5.
to help prevent leakage of molten weld metal (Figure 2).
Check lug position before initiating weld reaction.
6.
After the reaction, allow 30 seconds for the weld metal and slag to solidify.
7.
Remove all packing material as soon as possible.
8.
Note: Use only for connections to contact rail. Do not use for connections to running rail or
load bearing rail.
TECHNICAL SUPPORT:
www.erico.com
IP7461_C
INSTRUCTION SHEET
1 OF 1
© 1993, 2012, 2014
ERICO International Corporation
WARNING:
ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at
1.
www.erico.com and from your ERICO customer service representative.
ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.
2.
All instructions must be completely followed to ensure proper and safe installation and performance.
3.
Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property
4.
damage, serious bodily injury and death.
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.