Eschenbach Optik iQon Agilo - Manual (Page 6)

Page 6
2.2 Using the iQon with other cameras
If you use the iQon with a camera other than the Agilo, please follow the
instructions supplied with the camera. The camera should be plugged
into the iQon camera connection point (if it is an Ash camera) or
alternatively video can be plugged into the S-video socket.
Please note that the Zooming function on the iQon only operates with
the Agilo camera and will not be available with other cameras.
2.3 Connecting the iQon
Refer to the figures on the following pages, which show the positions of
the connection points for the various cables.
a) The camera should be connected as described in the previous
sections above.
b) Disconnect the monitor cable from the computer.
c) Connect one end of the Ash VGA cable (socket to plug type) to the
connector labelled ‘COMPUTER’ on the iQon front panel. Connect
the other end of the cable to the computer’s video port.
d) Connect the free end of your monitor cable to the connector
labelled ‘MONITOR’ on the iQon rear panel.
e) If required connect the footswitch cable connector to the port
labelled ‘FOOT SWITCH’ on the iQon front panel.
f) Plug the connector from the power supply into the port labelled 12V
and plug the power supply into a wall socket.