Gardman 10 Large Solar Lights - Manual (Page 2)

Assembly:
n Assemble the leg section by adding the spike to the stem.
n Remove the battery isolation tab to activate the light.
n Add the lens to the top section by pressing into position and
twisting into the availble slots: ensure that it is firmly locked
into place.
n Do not add the top to the stem section at this stage or damage
may occur when positioning - see ‘installation’ below.
Installation:
n Maximum sunlight will give the internal battery the best charge
and so give best results.
n Position solar lights where they are free from cover or shade
and, ideally, in a position that receives full sun throughout
the day.
n Avoid other light sources which may cause solar lights to flicker
on and off. Also allow a space of approx. 1.5m (5ft) between
solar lights.
n Push the spike carefully into the ground: if the ground is hard,
first make a hole to avoid damaging it.
n When the spike and stem are in the desired position, add the
top section (push fit).
n Solar lights will not be very bright or long lasting until a full
day’s sunlight has been received.
n Alternatively, batteries can be charged to full capacity in a
battery charger before use.
Maintenance:
n If solar panels get dirty, the charging capacity will be reduced.
Clean panels occasionally with a damp cloth – avoid harsh
detergents or solvents as these can damage the panel.
n Batteries can be given a temporary boost in a battery charger if
there has been limited sun or extra light is needed for a
special occasion.
n Batteries may need replacing after 1-2 years, depending
on the conditions they have had to endure. The batteries
are housed under the head of the light and can be easily
accessed by removing the lens and unscrewing the
underside of the top.
n The battery (1 x AA per light) can be replaced with any 1.2v
rechargeable ones available in retail outlets: choose a low
power output (mAh). Gardman replacement batteries are
ideal for the purpose.
n Low winter light levels or harsh weather in your locality may
lead you to decide to store your solar lights indoors until
conditions improve. If so, clean and dry the lights, turn off or
remove the batteries: store in a dry spot and reassemble in
spring as described in ‘installation’.
Troubleshooting:
If your solar light does not operate properly at night it may be
caused by one of the following:
n Ensure the switch, if present, is in the on position and any
battery tabs removed.
n Low light levels caused by the position of the light, lack of
sun or short daylight hours will shorten the light duration.
n Other lighting can cause flickering in a solar light or even
prevent it operating.
n Check the batteries in case they need replacing: see
‘maintenance’ above.