Bowflex Elite™ Plus home gym - Manual (Page 14)

A-12
Figure 14
Leg Extension
Seat
Roller Tube
Spacers
Support Tube
Bracket Hooks
Back Edge
Step 14 - Attach the Leg Extension Seat to
the Main Assembly
Locate the following items:
• Fr om Step 13 - Leg Extension Seat Assembly
• From Step 12 - Main Assembly
The Leg Extension Seat Assembly is removable, and can be
attached to the Rear Leg Assembly easily by placing the Rail
Bracket Hooks over the Rear Rollers.
Place the Rail Bracket Hooks onto the Roller Tube Spacers
(sandwiched between the Rear Leg and the Foam Rollers).
Once the Support Tube Bracket Hooks connect with the
Roller Tube Spacers, slightly “roll” the back edge of the Seat
down to lock into place.
Warning: For your safety, always ensure that the
Support Tube Bracket Hooks fully engage with the
Roller Tube Spacers.
To remove the Leg Extension Seat Assembly, reverse
this procedure.
Step 15 - Attach the Lat Cross Bar to the
Upper Lat Tower
Locate the following items:
• Item #22 - Lat Cross Bar - Do not unwrap cables!
• Item #23 - Upper Lat Tower
• Item #H - (2) 3/8" X 3" Button Head Screws
• Item #N - (4) 3/8" Washers
• Item #O - (2) 3/8" Nylock Nuts
Align the holes in the Lat Cross Bar (Item #22) with the holes in
the bracket on the Upper Lat Tower (Item #23).
Place (2) 3/8" Washers (Item #N) over the ends of
(2) 3/8" X 3" Button Head Screws (Item #H) - one washer per
screw. Thread the screws through the aligned holes, then
secure by placing (1) 3/8" Washer and (1) 3/8" Nylock Nut
(Item #O) over each screw and tighten.
Completely tighten hardware installed during
Step 15.
Assembly Guide
Figure 15
N
23
22
H
O
Lat
Tower
Bracket