HYDAC EDS 8000 - Manual (Page 4)

User manual EDS 8000 US Page 4
Status 09.09.2009 HYDAC ELECTRONIC GMBH Part No. 669820
4 Controls of the EDS 8000
2 keys (↓↑ and E) for adjusting the switch points, switch-
back points and additional functions
4-digit
digital display
LED backlight
to indicate switch points
(red = active / green = inactive)
Use the keys to select the next menu point, or alternatively to adjust the values.
• To scroll through the menu
• To increase the value
• Hold the key down to fast-scroll
through the parameter values
• To select the menu point
• To confirm value
5 Digital display
Once the power supply has been switched on, the device briefly flashes "EdS", and then
begins to show the actual pressure.
To check the unit of measurement being used for the pressure indication, press the right-
hand key. Depending on the setting, bar, psi or MPa will be shown.
The backlight changes colour according to the settings of the switch outputs and their
switch points, i.e. when the switch output is inactive or low-level, the relevant backlight is
"green", when the switch output is active or high-level, the relevant backlight is "red".
Backlight
Backlight
for switching output 1 for switching output 2
E
E