Induro 3D PanHead - Manual (Page 3)

1
Install by screwing the
head clockwise on to the
3/8 thread mounting thread
of tripod plate. Once it is
hand tight secure by fully
tightening the three head
locking screws from below.
2
A patented dual lock
quick release system
when used properly offers
two levels of security for
your gear. To remove the
quick release plate, squeeze
both levers and pull the
larger plate locking lever
out. The quick release plate
will disengage so it can
be removed.
3
To reconnect the quick
release plate, insert the
angled part of the plate into
the groove on the opposite
side of the locking lever and
press down flat. The locking
levers will automatically
engage the locking system
and the locking levers will
return to the safety lock
position. Press the plate
locking lever in firmly
to secure.
4
Horizontal rotation or
panning can be easily
accomplished by first
loosening the pan lock
and then rotating head on
platform. Once in position
tighten the pan lock securely.
5
Front to rear angle or
tilt adjustments can
be easily accomplished
by first loosening the tilt
lock (be sure to hold on
firmly to balance weight of
the camera). Position as
required and then tighten
handle securely. You have
the same control and lock
available on the other axis
for horizontal angle or
tilt adjustments.
6
Depending on your
requirements you may
find it convenient to reorient
the camera or lens 90 degrees
on the quick release and
remount so that the tilt
controls give you different
positioning support.