Koolance CTR-SPD1224-R - Manual

CAUTION: Improperly connecting the speed controller can damage it, the
pump, or the power supply. Ensure that total device load does not exceed the
maximum rating of the controller (36W@12VDC, 50W@24VDC). Ensure that
the connected device will safely accept the voltage being supplied (12V or 24V
depending on the jumper setting). !
CTR-SPD1224 Installation Guide v 1.0
1
Power In
(12VDC)
2
Power Out
(Pump, Fan, etc.)
The Koolance CTR-SPD1224 uses voltage
control to throttle speeds for 12VDC pumps or
fans. With a jumper setting, it will also step-up
and throttle voltage for 24VDC devices. CTR-
SPD1224 requires a 12VDC input.
Do not operate components at voltages which
exceed their specifications. Running a 12V-max
pump at 24V from the speed controller can
damage the pump.
To avoid damaging the speed controller,
do not connect devices which exceed the
controller’s maximum power rating (36W@12V,
50W@24V).
If your Koolance pump has a 3-pin power connector, plug it directly into the speed
controller’s “Power Out” connection. Connect the power supply’s 4-pin Molex plug
to the speed controller’s “Power In” connection.
Connect 3-Pin Pump Connect 4-Pin Power Plug
If your Koolance pump has a 4-pin
Molex connector, you must use the
plug adapter included with your speed
controller.
Connect the pump to the 4-pin plug adapter. Connect the plug adapter’s 3-pin to
the speed controller’s “Power Out”. Connect the power supply’s 4-pin Molex plug
to the speed controller’s “Power In” connection.
Connect 4-Pin Pump to Plug Adapter
Connect 3-Pin Plug Adapter to Controller
Plug Adapter
Pump Power Supply
Pump tachometer signals are not used by the speed control-
ler. If your pump has an integrated speed knob, it should
be left on the maximum setting when adjusting speed via
the Koolance controller.
Plug Adapter
Pumps with built-in
control should be left on
maximum speed
CTR-SPD1224 has a jumper to select from 12V
(max) or 24V (max) speed control.
CAUTION: Do not power 12V
pumps or other devices with the
24V setting! This can permanently
damage the attached device. !
Plug Adapter
Connect to
Pump
Connect to
Controller
Voltage
Jumper