Landoll 5K977 TIRE TRACK REMOVER KIT - Manual

ASSEMBLY OF THE 5K977 TIRE TRACK REMOVER KIT
S-Tine
Bracket
Tooth Bar
Tube
Channel
Adapter
5” Strap
8” Strap
Duckfoot
Point
Reversible
Point
Screw
½”-13 X 6”
Screw
½”-13 X 8”
Screw
½”-13 X 1½”
½” Lockwasher
½”-13
Hex Nut
Clamp
7/16”-14
Lock Nut
Screw
7/16”-14 X 3 ½”
3/8”-16
Flange Nut
Cultivator
Bolt
Centered behind each tractor tire, attach a set of Channel Adapters to the Pulverizer frame using the 8” Straps and
½” X 8” Bolts, Lockwashers, and Hex Nuts. Ensure that the Channel Adapter end with four holes is downward.
Prior to inserting the bottom 8” Bolts line up the S-Tine bracket with the four lower holes on the Channel Adapter.
Attach with 8” Bolts and Hex Nuts in the top holes. The 1 ½ Screws, Lockwashers and Nuts are inserted in the two
bottom holes. Tighten all fasteners at this time.
Attach Tooth bar Tubes to the S-Tine Brackets using 5” Straps and ½” X 6” Bolts, Lockwashers, and Nuts. Tighten
all fasteners at this time.
Locate and install S-Tines as needed to cover tractor tire tracks. The recommended positions of the S-Tines is to
set the middle tine in line with the center of the tractor tire and the outer tines just beyond the outer edge of the
tractor tire.
Attach the Duckfoot and Reversible Points to the S-Tines using the Cultivator Bolts and 3/8” Flange Nuts. The
suggested pattern is to use the Reversible Point on center tine and Duckfoot Points on each side. If needed,
additional tines may be purchased and installed.
Check for interference between tractor tires and S-Tines. If this occurs, the Tooth Bar Tubes can be mounted
behind rearmost vertical member on the S-Tine brackets.
1212 5K978