Lenze 9400 - Manual (Page 713)

Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06
713
14 Parameter reference
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
14 Parameter reference
All parameters for controller parameter setting or monitoring are stored under "codes".
• The codes are numbered and indicated by the prefix "C" before the code, e.g. "C00002".
• For the sake of clarity, some codes contain "subcodes" for saving parameters. This Manual uses
a slash "/" as a separator between code and subcode, e.g. C00118/3".
Parameters available in the controller only from a certain software version are marked accordingly
("From software version Vx.x").
The parameter descriptions are based on the software version V12.00.xx.

Tip!
For quick reference of a parameter with a certain name simply use the index of the online
documentation. The index always contains the corresponding code in parentheses behind
the name.
For general information on how to read and change parameters, please see the online
documentation for the »Engineer«.