Lowell 30WK - Manual

Instruction Sheet
P/N: 20148
Issued: 9-10-14
Lowell Manufacturing Company 100 Integram Drive Pacific, Missouri 63069 U.S.A.
Call: 800-325-9660 Fax: 636-257-6606 Click: www.lowellmfg.com
30WK
INSTALLATION SHEET
The 30WK wall mounting kit allows the installer to mount the
Lowell MA30 mixer/amplifier to any flat wall surface such as a
telephone closet termination board.
Step 2
2 Remove the two (2) chassis cover screws as shown in figure .
Also remove the same two (2) cover screws on the opposite side
of the chassis.
Screw Note:
The chassis screws that you removed, have a unique metric size
and thread pitch. Discard those screws. Provided with the kit are
8-32 self-tapping and 6-32 self-tapping screws that will use the
existing metric threaded holes as starter holes and will thread
new tapped holes that will securely attach the mounting brackets.
1
1
Step 1
The 30WK wall mounting kit includes two (2) brackets, two (2) 8-
32 self-tapping screws, and four (4) 6-32 self-tapping screws as
shown in figure .
1
1
3
4
2
Remove Remove
8-32 black self-tapping screw
6-32 black self-tapping screws
Step 3
3
Line up a bracket with the holes in the MA30 and securely tighten
the one (1) 8-32 self-tapping screw and the two (2) 6-32 self-
tapping screws where shown in figure . Line up the second
bracket with the holes on the opposite side of the MA30 and
securely tighten the one (1) 8-32 self-tapping screw and two (2)
6-32 self-tapping screws. The completed assembly with both
brackets installed is shown in figure .
4
Step 4
Hold the amplifier with mounting brackets attached against the
wall or surface where you want to mount the amplifier . Note that
the knobs can be positioned up, down, or to either side as
desired. Mark the slotted holes on the surface. Partially screw
four (4) mounting bolts (provided by the installer
– a screw with a
3/8" diameter head will work best) into the surface where you
have marked the slot leaving the head about 1/4" off of the
surface. The amplifier and brackets will now simply slip right over
the screws and the screw heads will rest in the slots. Finally,
tighten the four (4) mounting screws.