Multiquip STX55Y6 - Manual (Page 23)

STX-SERIES • RIDE-ON POWER TROWEL — OPERATION MANUAL — REV. #0 (03/15/06) — PAGE 23
/02) — PAGE 23
STX-SERIES — TROWEL SETUP
Trowel Setup
The purpose of this section is to assist the user in setting up a
NEW trowel. If your trowel is already assembled, (seat, handles,
knobs and battery), this section can be skipped.
Before packaging and shipping, this STX SERIES Ride-On
Power Trowel was run and tested at the factory. If there are
problems, please let us know.
1. Remove the seat from the protective wrapping.
2. Remove the bolts on the bottom of the seat, and place seat
on the seat mounting plate, then insert the bolts through
the holes or slots on the seat mounting plate and tighten.
Seat Assembly
The seat is not installed on the trowel for shipping purposes. To
attach the seat perform the following:
To install the battery on the trowel, make sure that the battery is
well seated in the battery box. Connect the positive cable to the
positive terminal on the battery first, then connect the negative
cable to the negative terminal. Close the plastic battery box cover
and secure the battery box.
The STX trowels have a seat that
is mounted on tracks, similar to an
automobile seat. This seat can be
adjusted fore and aft via the control
lever under the front of the seat.
The new trowel cannot be put into
service until the pre-setup
installation instructions are
completed. These pre-setup
instructions only need to be
performed at the time of unpacking
a
NEW trowel.
Use all safety precautions specified by the battery
manufacturer when working with the battery. See further
specific safety information on page 16 of this manual.
CAUTION CAUTION CAUTION CAUTION CAUTION
Battery Setup
This trowel was shipped with a wet charged battery. This battery
may need to be charged for a brief period of time as per the
manufacturer instructions.
Figure 5. Battery and Battery Box
NOTE
NOTE