Orbit Baby G3 Stroller Base and Stroller Seat - Manual (Page 20)

12 – ENGLISH – Manual Text Booklet – Orbit Baby Stroller Seat and Stroller Base
⃞ Press release tab on seat shell. Slide plastic harness stopper from slot and pull out through
upholstery.
⃞ Re-thread each shoulder strap through the correct upholstery slot and insert stopper into the
corresponding shell slot at the new height. You should hear a CLICK. Ensure the harness is
secure by tugging on the shoulder strap. Reattach upholstery to stroller seat. Check that the
shoulder straps are threaded into slots at the same height and that neither shoulder strap is
twisted.
Using Your Stroller
⚠
WARNING
⚠
TO PREVENT FALLS:
◦
Always grasp both side handles when rotating or undocking the seat.
TO AVOID PINCH HAZARD:
◦
When adjusting and docking the stroller seat, always ensure all children's body parts are
clear of moving parts and the stroller base. Keep your hands clear of moving parts when
adjusting the stroller seat.
◦
To avoid pinching your child’s hands, feet or legs, adjust the footrest to position 1 before
rotating or docking the seat rear-facing.
 Recline, rotate and undock the stroller seat
⃞ Use the release levers Ⓠ to recline, rotate and undock your stroller seat from a SmartHub Ⓕ.
⃞ Recline the stroller seat to one of three positions by pulling on one or both release levers and
moving the stroller seat. Let go of the release lever(s) to lock the stroller seat in position. You will
hear a CLICK. Ensure the stroller seat is locked in one of the three recline positions by tugging on
the stroller seat. Only use the upright position once child has full control of head and neck.