Powertrax 4110 - Manual (Page 24)

24
The following [WARNING] and [CAUTION] information is supplied to you for
your protection and to provide you with many years of trouble free and safe
operation of your Richmond Gear product.
Read ALL instructions prior to operating transmission and/or ring and pinion.
Injury to personnel, transmission or ring and pinion failure may be caused by
improper installation, maintenance or operation.
•It is dangerous to get under a jacked-up vehicle.
The vehicle could slip off the jack and fall on you. You
could be crushed. Never place any part of your body
under a vehicle that is on a jack. Never start or run the
engine while the vehicle is on a jack. If you need to
get under a raised vehicle, take it to a service center
where it can be raised on a lift.
• Hot oil can cause severe burns. Use extreme care
when removing lubrication plugs and when working
close to a unit that has been in operation.
• Check lube level between scheduled lube changes to insure that proper lube
level is maintained. Inspect vent plug to insure it is clean and operating. Inspect
the tightness of mounting bolts, misalignment of connecting shafts, lube leak-
age, excessive heating, or any unusual noise or vibration.
•Serious personal injury may occur as a result of improperly performed mainte-
nance, adjustments or repairs.
•Do not attempt any of the maintenance, checks or repairs described on the fol-
lowing pages if you are not fully familiar with these or other procedures with
respect to the transmission, or are uncertain as to how to proceed. Have the
necessary work done by a properly equipped and qualified workshop.
•Always be extremely careful when working on the transmission. Always follow
commonly accepted safety practices and general common sense. Never risk
personal injury.
(continued on next page)
WARNING! CAUTION!
DANGER!
WARNING!
IMPORTANT INFORMATION
Please Read Carefully