Quadrox WebCCTV Installation Manual - Manual (Page 7)

WebCCTV Installation Manual 7
Version 4.4 Series
2.2 Starting up for the first time
This chapter provides information on the following procedures:
Turning the power on and off
Logging on to the XPe system
Desktop icons overview
Changing the password
Setting the time
Changing keyboard language
Adjust screen resolution
Connect monitor, keyboard and mouse before turning on the power and configuring
WebCCTV.
2.2.1 Turning power on/off
2.2.1.1 Turning power on
To turn the power on, follow the steps below:
1. On the front side of your WebCCTV, you’ll find an On/Off button. This is a one-touch
button. When pressing it briefly, WebCCTV will begin its start-up procedure. You can
verify the correct start-up sequence by checking the following:
The fans are turning and make a humming noise.
The power indicator is illuminated.
The hard disk indicator is flashing.
2. When you have a monitor connected, you can see that:
First it lists all the hardware components.
Second it starts loading the Windows XPe operating system
3. After about 1.5 to 2 minutes, the WebCCTV should be fully started.
The first time you turn on the power of your WebCCTV, its initial screen will be the Windows
XPe logon screen.
WebCCTV does not logon automatically by default.