S&S Cycle Frame Lock - Manual (Page 4)


6- Mount the eyelet bracket with the included hex bolts securely. This will level the frame clamps.
7- Remove the eyelet bracket and tighten the sockethead screws in the frame clamps.
Do not ride motorcycle with eyelet bracket in place for any reason. Eyelet bracket must be removed when motorcycle comes out of Frame
Lock™ mount.
ATTACH MOTORCYCLE TO FRAME LOCk TM FOR TRANSPORTATION
1- Attach eyelet bracket to frame clamps and tighten hex bolts securely. Position motorcycle squarely and centered over Frame Lock base unit.
2- Slide the pin through the Frame Lock and eyelet bracket. Use a cotter pin or padlock (both customer supplied) to lock the pin in place. Slide
the pin in place while you are seated on the motorcycle. In is not necessary to have someone assist you with pin insertion. If the holes do
not line up perfectly it means you are not straight on the Frame Lock base. Turning the handlebars left or right will move the motorcycle
horizontally to allow the pin to slide in. Be sure to install a locking device (customer supplied) in the pin once it is inserted.
REMOVINg MOTORCYCLE FROM FRAME LOCk
1- Remove the pin while you are seated on the motorcycle.
2- Roll the motorcycle away from the Frame Lock base plate. Remove the eyelet bracket before riding the motorcycle.
Do not ride motorcycle with eyelet bracket in place for any reason. Eyelet bracket must be removed when motorcycle comes out of Frame
Lock mount.
Picture 9
CAUTION
Picture 10
CAUTION