Sensaphone 2.8K Type Ultra Low Temperature Sensor - Manual

Instructions for 2.8K Type Ultra Low Temperature Sensor in Glass Bead Vial
(FGD-0107-TEF)
Instructions for Models 400, 800, 1400, 1800, 2800, and IMS-4210-E
The probe may be connected to any available input terminal. Refer to your user’s manual for
configuration and programming. To connect the probe:
1. Remove any existing wiring or sensors (including local thermistor) from the input terminal.
2. Attach wire from the weatherproof temperature probe to the input terminal and ground
respectively.
Instructions for WEB600, CELL682, Express II and Sensaphone 2000
The probe may be connected to any available input terminal. Refer to your user’s manual for
configuration and programming. To connect the probe:
1. Remove any existing wiring or sensors from the input terminal.
2. Place the corresponding input shunt in the ‘a’ position for Express II, or the TMP/DRY
position for the 2000.
3. Attach wire from the temperature probe to the input terminal and ground respectively.
4. Program the input type for a 2.8K thermistor in either Fahrenheit or Celsius.
Warning: Do not submerge.
© 2009 Sensaphone 901 Tryens Road, Aston, PA 19014
For Technical Support call 877-373-2700 or E-mail [email protected]