STEMCO Axle Pro - Manual (Page 11)

Axle Pro Equipment Instruction Guide
For your protection, use Standard Shop Safety Procedures during this process
Page 11 of 24 01 577 0092 SEPT 2011
Step 3: Axle Alignment Assembly Cont…
f. Tighten welded nuts into bottom side of upper plate; tighten
four nuts against lower plate. Nuts against lower plate should
be tightened with torque wrench 36 ft/lbs.
Do not tighten nut
on rear adjusting rod. (See Photo 3D)
g. Ensure plates are mounted squarely onto axle. Visually check
for gap between plates and axle. (See Photo 3E)
h. Ensure mounting plates are securely attached. Inspect this by
grasping upper plate and attempt to move side to side. Plates
must be secure. (See Photo 3F) If loose, then tighten nuts
again & re-check.
i. Remove one of the nuts holding centering mandrel together
and remove mandrels. (See Photo 3G)
Photo 3D
Photo 3G
Photo 3E
Photo 3F