TruXedo TonneauMate - Manual (Page 3)

ff
sUppOrt arM installatiOns
Remove all hardware from inside the toolbox. Slide support arms into channel by aligning square head bolt until support arm slides in. Orient
left/right support arms as shown below. Do not tighten fasteners at this time. The support arms need to slide in and out for installation. Close
lid for ease of installation.
When Used With TruXedo Deuce Tonneau Cover:
Deuce kits will not need the mounting rails, seals, or adjustable clamps. For ease of installation on the Deuce, roll cover up and open Deuce
from front. Go to step 3 for installation.
1
The toolbox can be mounted with many different applications. Choose one best for your application. When choosing the location to mount the
toolbox, keep in mind to allow room for opening lid. The illustrations below show a few different ways to mount the mounting rail.
Note: The toolbox may be mounted at the front, center, or rear of truck box. Use two adjustable clamps per rail, keep clamps towards the
ends of mounting rail. Use rail seal only with no tonneau cover applications or some top mount applications. No seal is needed when mount-
ing to an existing tonneau cover like the ones shown below.
2
MOUnting rail installatiOns
No Tonneau Cover Lo Pro TruXedo TruXedo Original Other Tonneau Covers
Mounting Rail Seal
Adjustable
Clamp
sUppOrt arMs
sUppOrt arMs
Install clamps
towards end of
mounting rail
End View
of Toolbox