Weidmuller PT 100/4 signal conditioners for voltage output - Manual (Page 2)

16
1 General instructions
The WAVESERIES signal conditioner PT 100 should only be
installed by qualified staff. The signal conditioner PT 100 should
only be powered up following professional installation.
2 Application
The WAVESERIES signal conditioner PT 100 can be used to con-
nect PT 100 sensors as well as converting temperature data into
standard linear voltage signals. The temperature range can be set
by DIP switches on the printed circuit board.
The signal conditioner PT 100/4 can be connected to 2-, 3- and
4-wire temperature sensors.
3 Mounting and dismounting
Warning!! Mounting and dismounting may only be carried out
when the power supply has be disconnected. Failure
to observe will lead to considerable damage!