Yamato Scientific IN603W Low Temperature Incubators - Manual (Page 27)

23
Operation Method
Program Operation
3 Set step number and start wait period/
time
AUTO START
FIXED TEMP
AUTO STOP
PROGRAM
STANDBY
END
HEATER FUNCTION PROGRAM MENU ENTER CANCEL
POWER
TROUBLE
℃
First step S01
Program OPR
REFRIGE
DEFROST
①
The initiating step input screen is displayed.
The Sub Display displays "First step" and the
step number blinks.
② Select the step number using the"▼▲" and then
check it using the ENTER key.
™ The "steps that are not set" and "step within repeat"
are not displayed. If no program is registered (no
steps are used), the buzzer sounds with a message
on the Sub Display. In this case, register program
using the PROGRAM key and start the step again.
NO program
Registered
(Display in case no program
is registered)
③ The operation start wait period/time input screen
is displayed after the step number is decided.
Display the operation start wait period/time using
the "▲▼".
Input the operation start wait period when the
setting of timer mode shows "Time". Input the
operation start time when it shows "Clock".
Wait ST 30min
Program OPR
Start Time 13:00
Program OPR
(Operation start wait
period edition screen)
(Operation start time
edition screen)
™ Pressing the CANCEL key quit the setting of auto
start operation.