3D Robotics Digital Airspeed Sensor User Manual

Pixhawk digital airspeed sensor, Assemble

Advertising
background image

PIXHAWK DIGITAL AIRSPEED SENSOR

Digital airspeed sensor

Pitot tube

Rubber tubing

Assemble

Four-wire I

2

C cable

Connect the four-wire cable to the four-position port on the airspeed sensor.

Cut the piece of rubber tubing in half. You should have two pieces of equal length.

Attach a piece to each of the input sensor cones on the board.

Connect the tube attached to the cone on the top of the board to the longer

extension on the pitot tube, and connect the tube attached to the cone on the

main, lower section of the board to the smaller extention on the pitot tube.

pitot tube

complete assembly

sensor cones

Advertising