3D Robotics GoPro HERO3 stabilization system User Manual
Parts, 1 attach camera, 2 connect
1
Parts
Tarot gimbal
GoPro HERO3 stabilization system
IRIS+ mounting screws
(2)
Configuration cable
Gimbals arrive preconfigured and ready
to fly. For information on changing
configuration and updating the
firmware, visit 3dr.com/learn.
Extra parts
servo cable
split-wire servo cable
rail mounting hooks (2)
X8/Y6/QUAD mounting hardware
(instructions included)
Remove the two screws securing the blue face plate,
and remove the plate.
1
face plate
remove
Slide camera into housing with
the lens nearest the top-right
corner.
2
!
Important note: Make sure that the WiFi on your GoPro
is turned OFF at all times when in use with IRIS+.
remove
1 Attach Camera
Place the blue face plate over the camera, and secure from the
back with the two original screws.
3
Add face plate.
tighten
Thread cables here.
Locate the black and white two-wire cable protruding
from the bottom of IRIS.
1
Thread the cables through the interface plate. Locate the pins
on the Tarot board. Connect the black wire to a - (ground) pin
and the white wire to the T (tilt) pin.
2
Follow these instructions to connect the gimbal to IRIS. This
will allow you to adjust the tilt of the camera in flight using the
controller. To enable automatic camera stabilization without
remote control, skip to the step 3: power.
Attach black wire
to ground (-).
ground (black)
tilt (white)
Attach white wire
to tilt (T).
2 Connect
GoPro not included
User Guide