Clearances, Cutout dimensions – Rockwell Automation 2711 PanelView 300 Keypad Terminal Installation Instructions User Manual
Page 6
6 PanelView 300 Keypad Terminals
Publication 2711-IN027C-EN-P - February 2009
Cutout Dimensions
Use the full size template shipped with the PV300 terminal to mark the cutout
dimensions. The figure below shows a reduced size cutout.
Clearances
Allow adequate clearances for mounting, air flow, maintenance, and for installing a
memory card and legend insert.
R 4.5 mm dia.
(0.178 in.)
178 mm
(6.99 in.)
140 mm
(5.53 in.)
120 mm
(4.71 in.) 109 mm
(4.29 in.)
Side, Top and Bottom Clearances
Approximately
216 mm (8.5 in.) is
required to insert
and remove a
memory card with
the memory card
retainer.
69 mm
(2.73 in.)
Leave 64 mm (2.5 in.)
for Mounting and Air Flow
Leave 64 mm (2.5 in.)
for Mounting and Air Flow
Memory Card Retainer
TERMINAL CUTOUT
Use Full Size
Template shipped
with Terminal
135 mm
(5.3 in.)
Back
Card