Rockwell Automation 6189V-HPMOUSEP Panelmount Industrial Pointing Device User Manual
Page 6
6
Publication 6189-IN001C-EN-P - October 2007
6. Alternately tighten the self-locking nuts (use 3/8 inch socket) until the
6189V-HPMOUSEP is held firmly against the panel. See recommended
tightening sequence below. The amount of torque required increases
significantly as the gasket reaches the proper compression. Tighten nuts to a
torque of 2.3 N-m (20 in-lbs).
Connecting the 6189V-HPMOUSEP
The 6189V-HPMOUSEP plugs into the mouse port of your industrial computer.
Consult you industrial computer user manual for specific details.
ATTENTION
Tighten mounting nuts to a torque of 2.3 N-m (20 in-lbs) to provide a proper seal and
prevent damage to the 6189V-HPMOUSEP. Rockwell Automation assumes no
responsibility for water or chemical damage to the pointing device or other equipment
within the enclosure because of improper installation.
1
3
2
5
4
6
7
8