Bang & Olufsen BeoSound 1 - User Guide - Manual (Page 20)

Use the PIN code system
It is your own choice whether or not to
activate the PIN code system. However,
if you choose to activate the system,
your BeoSound 1 is protected against
theft with a fourdigit PIN code.
The use of a PIN code means that if your
BeoSound 1 is disconnected from the
mains for more than 30 minutes, the
system can only be activated again by
keying in your own personal PIN code.
If the PIN code is not entered, the
BeoSound 1 automatically switches to
standby after 3 minutes.
If a wrong PIN code is entered, you get
five attempts to key in the code, after
which the system is switched off and
cannot be switched on for 3 hours.
Should you forget your PIN code, please
contact a retailer who can assist you in
receiving a Master code from Bang &
Olufsen. You need the Master code to
reactivate your BeoSound 1.
Enter the PIN code
If the PIN code system is activated and your
BeoSound 1 is disconnected from the mains,
you are requested to key in the four-digit PIN
code when the system is first switched on.
The cue Pin is displayed shortly.
The display changes to four
squares
Press or to reveal digits
The squares change to
underscores and the first digit is
shown in the display
Press STORE to store the
displayed digit and proceed to
the next
The digit is replaced by a square
and the next underscore will
blink
Press STORE when the last digit
is displayed
BeoSound 1 switches on to the
last used source. If radio was
used last, the program number
is shown in the display
NOTE: If a wrong code is entered the second
time, the cue Err appears in the display, and you
must enter and confirm the code again.
Activate the PIN code system
The PIN code system is easily activated, and
you choose the four-digit code yourself.
Press twice when the set is in
standby
Press STOP to key in a four-digit
PIN code of your own choice
Pin appears briefly, and then
four underscores appear
Press or repeatedly to reveal
digits
The digits are shown in the
display
Press STORE to accept the
displayed digit and proceed to
the next
The digit is replaced by a square
and the next underscore will
blink
Press STORE when the last digit
is displayed
The display returns to four
underscores and you must
confirm the PIN code by
entering it again
NOTE: If you accidentally store a wrong digit,
pressing STOP will delete all digits again, and you
can enter new ones.
20
Pin
oooo
3 _ _ _
STORE
o _ _ _
STORE
Pr 8
STOP
Pin
_ _ _ _
3 _ _ _
STORE
o _ _ _
STORE
_ _ _ _