Baumfolder BaumCut 31.5 (For serials 76N1101 thru 78N1000) - Manual (Page 30)

K4 - 2
1 2 3
4 5 6
7 8 9
C 0
x
D
i
PROGRAMMABLE
1 2 3
4 5 6
7 8 9
C 0
x
D
RAMMABLE PROGRAMMABLE
Setting of Measurements (Backgauge Movement) by Hand
4.0 Manual Operation
Press electronical hand wheel and hold it in this position; turn hand wheel
to the left = forward movement of the backgauge
or
to the right = reverse movement of the backgauge
The backgauge speed gets faster by turning the electronical hand wheel to the
left/right .
Cutting Line Indicator, Mechanical with Clamp
Lower clamp with pedal onto stock:
The front edge (a) of the clamp is identical to the cutting line and can be used as
cutting line indicator. Clamp can be stopped in any position.
Max pressure with fully activated pedal: 30 daN
Cutting Line Indicator, Optical
Actuate toggle switch (8) at main switch plate
Upper position: Table light ON
middle position: "0" - position
lower position: Optical cutting line indicator ON. A thin light line indicates the
cutting line; the table light is switched off at that moment.
a
3
8