Bird Technologies AT-500-Manual - Manual (Page 53)

Measure Match
35
Manual Scale
The cursor will blink on the maximum scale value and
Manual Scale will be highlighted.
1. Enter the desired value using the numeric key-
pad or change the value using the UP/DOWN
arrow keys.
2. Press the ENTER key. The cursor will blink on the
minimum scale value.
3. Enter the desired value using the numeric key-
pad or change the value using the UP/DOWN
arrow keys.
4. Press the ENTER key.
Note:
If an out of range value is entered,
the minimum (if under-range) or maximum (if
over-range) value will be substituted. If a maxi-
mum value that is lower than the minimum
value is entered the cursor will blink again on
the minimum value, waiting for a correct entry.
The actual range depends on the units selected.
Note:
Using the arrow keys will keep you
in the acceptable range. If you are not sure if
the larger value should be at the right or left
side of the scale, press the auto scale key to see
where the software puts it.
Turn Audio On/Off
The pitch varies with the match condition allowing you
to tune an antenna without having to look at the display.
1. Press the MENU key.
2. Press the SINGLE FREQ key.
3. Pressing the AUDIO key toggles between on and off.