Bogen TAMB2 - Manual

TAMB2
Telephone Paging Access Module
© 2010 Bogen Communications, Inc. All rights reserved.
Specifications subject to change without notice.
54-2190-02C 1101
The TAMB2 telephone paging access module provides a
means of interfacing various analog telephone port types to
a paging system amplifier to enable a facilityʼs telephone system
to be used to make audio announcements over its paging
system. The TAMB2 will interface to analog loop start and
ground start trunk ports as well as analog ring-up station lines.
It provides a means of connecting an external audio or music
source that will play over the paging system when no pages are in progress. A set of contacts are provided to signal external
equipment of the TAMB2ʼs operational status. Various DIP
switches and controls provide a wide range of flexibility over
how the access module will operate. The TAMB2 can be
mounted on a wall, mounted as a single unit in a rack (optional
rack mount kit required) or mounted 2-up, side-by-side in a
single rack space.
11s
6
1s MAX MAX
TIME TIME
MIN MIN
TIME TIME
10 0 10 0
1
0
1
VOX ENABLE
VOX DI
S
CONF TN
PRE ANN TN TRUNK MODE
STATI
ON
LOOP START
GND START
DETECT CPC
IGNORE
0
TONE TONE MUSIC MUSIC
VOX VOX
DELAY DELAY STATION/
TRUNK
PAGE
OUT
ON
PT PR G/S NO C T R
24VDC
150mA
CONTACT
CLOSURES
NC
1-RNG DLY
NO TI
MER
TRNK TMER
ANS IMMED
RANGE (SEC)
INHIBIT 1 1
100 - 200 0 1
50 - 100 0 1
1 - 50 0 0
PAGING PAGING
TIME TIME
<
<
<
<
TAMB2
TELEPHONE PAGING ACCESS MODULE
O
N 1 2 3 4 5 6 7 8 9
1 12 11 10 9 8 7 6 5 4 3 2
1. DIP Switches - Set various operational functions.
2. On/Power Indicator - When lit, indicates that the unit
is powered on.
3. Paging Time Control - Sets maximum time duration
of a page.
4. VOX Delay Control - Sets maximum silence period
allowed for an active page.
5. Tone Control - Sets the level of an announcement tone
the unit produces.
6. Music Control - Sets the level of an external audio
source that plays through the paging system when
no page is active.
7. Music Input - Hi-impedance unbalanced RCA input
for stereo or mono signals.
8. Station/Trunk - Tip and ring connections to a PBX
or CO line.
9. Page Out - Balanced, 600-ohm audio feed to the
paging amplifier.
10. G/S Terminal - Provides ground return from PBX
when using a ground start trunk port.
11. Contact Closures - One C-form contact set which
changes state when unit is active.
12. 24V DC - User-supplied power supply input; unit
must be powered in all modes of operation.