Diode LED Vertical Mounting Bracket - Manual

INSTALLATION GUIDE
Use a ruler and pencil to draw
a guiding edge. Mark where the
beginning edge of the channel
will be installed.
Mark holes where the mounting clip
will be fastened. Fasten two clips
per channel, each 1/4 distance the
full length of the channel from each
end. E.g. if the channel is 40 in. long,
mount each clip 10 in. from each end.
Fasten the mounting clips with an
electric drill and mounting screws.
Use applicable screw anchors if
required for installation.
Hold the channel up to the guide
and mounting clip. Mark the channel
where the top edge of the mounting
clip will be located.
Screw the allen hardware into the
vertical bracket (prongs of stopper
facing down) with a #2 allen wrench.
Slide the vertical bracket into the chan-
nel and tighten with the allen wrench.
Ensure the bottom edge of the allen
hardware meets the mark previously
noted on the channel.
Fasten the channel to the mounting
clip on the vertical surface with the
vertical bracket resting above the
mounting clip.
CHROMAPATH™ VERTICAL BRACKET
Page 1 of 1
1 2 3
4
5
6 7
V1.0