Metrohm 850 Professional IC Anion MSM-HC MCS - Manual (Page 89)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
4 Operation and maintenance
850 Professional IC – Anion MSM-HC – MCS
￭￭￭￭￭￭￭￭ 79
￭ Remove the backup ring from the pump head and lay to the other
parts.
1 2 3 4 5 6 7 8
Figure 38 Components of the piston cartridge
1 Piston cartridge screw 2 Retaining washer
3 Zirconium oxide piston with piston
shaft
Order number: 6.2824.070. 4 Spring retainer
5 Spring
Order number: 6.2824.060. 6 Inner plastic sleeve
Protects from metallic abrasion.
7 Piston cartridge 8 Backup ring
3 Cleaning the components of the piston
￭ Clean zirconium oxide pistons contaminated by abrasion or
deposits with pure abrasive cleaning powder, rinse particle free
with ultra pure water and dry.
Replace highly contaminated or scratched zirconium oxide pistons
(spare part: 6.2824.070 zirconium oxide piston).
￭ Rinse the other parts of the piston and dry with a lint-free cloth.
4 Assembling the piston
￭ Insert the inner plastic sleeve, spring and spring retainer into the
piston cartridge.
￭ Slide the zirconium oxide piston carefully into the piston cartridge
until its tip emerges from the small opening of the piston car-
tridge.
￭ Attach screw and tighten by hand.
Replacing the piston seal
The 6.2617.010 special tool (see Figure 39, page 80) is necessary in
order to remove the piston seal from the pump head. It consists of two