Metrohm 817 Bioscan - Manual (Page 54)

3 Operation
817 Bioscan
46
List of program instructions
The following program instructions can be added to the time
program on the
Program subpage:
Instruction Parameter entry Meaning
Mode DC, Pulse, Scan Select detector mode.
Cell On, Off Switch cell on/off.
Outputs 0, 1, * Set remote lines Aux1, Aux2, Cont1
and Cont2 to desired values. For entry
of the first value, enter
1 , 0 or * . For
entry of the other values, move the
cursor in front of the value to be
changed and enter
1 , 0 or * .
Range pA: 10 pA – 5 nA
nA: 0.1 nA – 50 nA
µA: 10 nA – 5 µA Set measuring range.
Offset -50, -40, -30,…50 % Set offset for measuring signal.
Valve Fill, Inject Switch connected injection valve.
Oven off, 15 ... 60 °C Set column oven temperature.
Autozero Trigger analog output signal auto
zero.
DC_E -2 ... +2 V Set
measuring potential (DC).
Filter 0.1, 0.2, 0.5 ... 5 s Set electronic damping for the
analog output signal.
Scan_E1 -2 ... +2 V Set sweep start potential E1.
Scan_E2 -2 ... +2 V Set sweep end potential E2.
Scan_Cycle half, full Select scan cycle type.
Scan_Rate 1, 2, 5, … 50 mV/s Set scan rate.
Links
The Links tab of the 817 Bioscan is used for COM port selec-
tion and settings (details see Section 5.2.4 in the Software
Manual for IC Net 2.1).