Hinkley Lighting BRYNMAR 1931 - Manual

assembly instructions
Family: Brynmar Item No. 1931 RB
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
1. To install glass panels, remove screws (3) which retain glass clips (4) in place - see
Drawing 1
2. Slide glass panels into cage, making sure bottom of glass is in front of tab in bottom
of cage.
3. Replace glass clips (4) using screws (3) that were removed earlier.
4. Mount bracket (5) to top of cage by removing screws (6), putting bracket (5) in
place and threading screws (6) back into hole they were removed from.
1. Fixture can now be lamped accordingly.
2. Slip roof (1) over center stem (7) and seat it properly on cage - see Drawing 1.
3. Thread top finial (3) onto end of stem (7).
4. To attach decorative leaves (10), screw stud (8) into hole (9).
5. Slip decorative leaf (10) over stud (8) and thread on decorative knob (11).
*** The construction of this fixture will be accomplished by first installing the
glass, making all necessary electrical connections, mounting the fixture to
pre-installed post, and then assembling the main body of the fixture.
start here
1931
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.
Drawing 2 - Fixture Mounting
Drawing 1 - Fixture Assembly
3
1
6
3
5
7
5
6
4
2
9 8 10 11
1. After wiring connections are complete, slip post fitter (A) over top of pre-installed
post (B) making sure all wire connections are tucked inside the pole - see Drawing 2.
2. When fixture is slipped over pole make sure no wires are being pinched between
the top edge of the pole and the inside of the post fitter.
3. Thread the 3 set screws (C) into pre-tapped holes in post fitter.
4. Tighten screws (C) to secure fixture to post.
1. Fixture is mounted using 3 - 1/4-20 set screws.
2. Make all necessary electrical connections following wiring instructions below.
2.7.08
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com