E-flite Sobre 3D Profile - Manual (Page 13)

13 E-flite Sobré 3D Profile Assembly Manual
 3. Position the carbon rods in the fuselage, gluing the
rods to the vertical fuselage ONLY. This will allow for
alignment of the fuselage in the next step.
Note: The length of the rods are:
XL = 5.9-inch (150mm)
L = 4.3-inch (110mm)
M = 3.9-inch (100mm)
S = 3.75-inch (95mm)
 4. With the airframe upright, check that the stabilizer
is parallel to the wing. Lightly twist the fuselage as
necessary for alignment.
 5. Use side cutters to trim any excess carbon rods
that extend beyond the top of the horizontal fuselage.
With the rods resting tightly against the carbon spine
and each other, use foam-compatible CA to glue the
intersection of the rods to the carbon blade spars.