E-flite Carbon-Z Scimitar BNF - Manual (Page 19)

EN
MAINTENANCE Servo Service
Nose Gear
1. Remove the three screws (A) from the steering servo.
2. Remove the steering linkage from the servo arm.
3. Remove the servo from the fuselage
4. Disconnect the servo connector from the servo extension
in the fuselage.
Assemble in reverse order.
Wing
1. Remove the wing from the model.
2. Remove the two screws (B) and aileron servo cover from
the wing.
3. Remove the linkage (C) from the servo arm.
4. Remove the servo from the wing (the servo connector
goes through a channel in the wing to the fuselage).
Assemble in reverse order.
Vertical Fins
1. Remove the wing and vertical fi n from the model.
2. Remove the two screws (D) and retainer plate from the
vertical fi n.
3. Remove the linkage from the servo arm.
4. Remove the servo from the vertical fi n.
Assemble in reverse order.
Vectored Thrust
1. Open the fuselage to gain access to the vectored
thrust servo.
2. Remove the four screws (E) from the servo.
3. Remove the linkage from the servo arm.
4. Disconnect the servo connector from the AUX1 servo
extension in the fuselage.
Assemble in reverse order.
2.5 X 8mm (3)
A
2.5 X 8mm (2)
B
C
2.5 X 8mm (2)
D
2.5 X 8mm (4)
E
19