BenQ PE6800 - Manual (Page 30)

30 Additional Information
Indicators
There are three indicators which show the status of the projector. Check the following for information about the
indicator lights. If there is anything wrong, turn the projector off and contact your dealer.
When the projector is in a normal state, ...
When the projector is in an abnormal state, ...
POWER LAMP TEMP STATE REMARK
Orange
Off Off
Standby mode.
Flashing
Green
Lamp standby mode. Cannot turn the projector off.
Green Power on.
Flashing
Orange
Lamp is cooling down. Cannot turn the projector on.
POWER LAMP TEMP STATE REMARK
Orange
Off Red
The internal temperature is too
high.
•
The intake ventilation or the
exhaust ventilation is blocked.
• The projector may be in a
poorly ventilated location.
• The ambient temperature may
be too high.
Solution:
•
Make that the ventilation
holes are not blocked.
• Relocate the projector.
• Stop using the projector until
the ambient temperature falls
within the specified range.
The maximum operating
temperature is specified as
35°C / 95°F.
Red Off
The projection circuit is working ,
or the lamp is abnormal.
Solution:
•
Restart the projector.
If this operation is repeated several
times and the lamp indicator remains in
red, replace the lamp and contact your
dealer for assitance.
Green
Flashing
Red
Off
Almost time to to replace the lamp.
The lamp has been used for 1000
hours. (The power is on.)
Solution:
•
Install a new lamp.
Orange
Almost time to to replace the lamp.
The lamp has been used for 1000
hours. (The power is off.)
Red
Time to to replace the lamp. The
lamp has been used for 1500 hours
Flashing
Red Flashing
Red
The cooling system has a problem. Contact your dealer.