E-flite DHC-2 Beaver 25e ARF User Manual
Page 14
Advertising
14
E-flite DHC-2 Beaver ARF Assembly Manual
9. Secure the spinner cone to the backplate with the
screws provided with the spinner. Use a #1 Phillips
screwdriver to tighten the two screws.
10. Carefully remove the hatch from the bottom of the
fuselage. It is held at the rear with two magnets. To open
the hatch, insert your thumb and index finger into the
cups and pinch towards the middle of the hatch. Then lift
towards one side to release one magnet and then pull up
and away from the model to release the second model.
Note: If you are not flying with floats you may wish to
cut the plastic cups out of the hatch and make two holes
for your fingers.
If you intend to fly on floats, then you may wish to leave
the cups in place.
Advertising