E-flite Taylorcraft 450 ARF - Manual (Page 8)

8 E-flite Taylorcraft ARF Assembly Manual
Aileron Servo Installation
Required Parts
Wing w/ailerons (R&L) Servo arm (medium length)
Micro pushrod connector (2) Pushrod connector backplate (2)
Servo mounting plate (R&L) Control horn (2)
Sub-micro servo (2) Y-harness
6-inch (152mm) servo extension (2)
2mm x 4mm machine screw (2)
2mm x 6mm sheet metal screw (8)
Pushrod wire, 3
3 / 4
-inch (95mm) (2)
5/16 x 5/16 x 1/2-inch (8 x 8 x 12mm) mounting block (4)
Required Tools and Adhesives
Pin drill Drill bit: 1/16-inch (1.5mm)
Side cutters String
Pencil 6-minute epoxy
#1 Phillips screwdriver Low-tack masking tape
  1. Use a pin drill and 1/16-inch (1.5mm) drill bit to
enlarge the outer hole in a medium length servo arm.
  2. Slide a micro pushrod connector into the hole drilled
in the previous step.
  3. Use a pushrod connector backplate to secure the
connector to the servo arm.
  4. Use side cutters to remove the remaining arm so it
won't interfere with the operation of the servo.