E-flite Carbon-Z Splendor BNF Basic - Manual (Page 7)

EN
1. Slide the horizontal tail tube ( A) into the hole in the rear of the fuselage.
2. Install the 2 piece (left and right) horizontal tail as shown.
3. Install 2 short screws in the forward holes in the horizontal tail.
4. Install 2 long screws in the rear holes in the horizontal tail.
5. Attach the linkage between the servo arm and the control horn on the
elevator using the included ball link ( B), nut (C), screw (D) and link cover (E).
Ensure the servo arms are in the correct positions, then adjust the linkages
to center the control surfaces.
6. When needed, disassemble in reverse order.
Installing the Horizontal Tail
A
B
D
C
E
Factory Servo Arm Settings
Fly the model at recommended settings before making changes.
The linkages installed at the factory position are chosen for the most
balanced aerobatic response and AS3X performance. Linkage connections
directly affect aircraft response and AS3X performance.
NOTICE: Moving a linkage to another position may block the servo arm or
require the gain to be adjusted.
Elevator Rudder Ailerons
L R
77